8051 Microcontroller Trainer
(EM - 001)
  • 8051 microcontroller trainer - (RM - 001)
  • Programming Software
  • Sample Codes
  • USB Cable A to B 1.5 m
  • RS232 Cable 1.5 m
  • Hard copy user manual
  • Laboratory PC

8051 Micro controller trainer is a benchtop kit that tends to familiarize the trainee with the different microcontroller components and connections. The kit is designed in the form of a lightweight portable Plastic case equipped with a real microcontroller and various electronic components related to its functions to allow wide ranges of experiments. Kit is based on Microchip 8051 Architecture Microcontrollers. Kit provides a large number of interface modules with configuration switches which open a wide range of experiments.

                                     
  • 8051 microcontroller trainer consist of
    • Embedded programmer (access via USB port with indication LEDs)
    • Included microchip AT89S52 8-bit microcontroller with 8KB of ISP flash memory - 12MHz OSC.
    • Integrated fixed DC power supply module: + 3.3V, +5V, +12V, -5V, -12V (fuse protected) with led indicators - accessed via 2mm sockets (for external modules)
    • Integrated variable DC power supply module: +1.25VDC to +5VDC or +1.25VDC to -5VDC (fuse protected) with led indicators - accessed via 2mm sockets (for external modules)
    • 8 Digital switches
    • Integrated pulse generator from 2 Hz : 1KHz
    • Dip switches for configuring microcontroller I/O ports
    • 4 x seven segment modules
    • 1 x (2 x 16 LCD module) contrast adjustable via potentiometer
    • 1 x (64 X 128 GLCD module) contrast adjustable via potentiometer
    • ADC: 1 x 4-channel12-bit resolution.
    • Port expander: 1 x 16-Bit remote bidirectional I/O port
    • 1 x keypad: 22-key (16-HEX key, 6-function key)
    • 1 x Piezo buzzer module
    • 1 x Speaker
    • 1 x Temperature sensor DS1820
    • 1 x Stepper motor interface Through ULN2803
    • 1 x DC motor interface
    • 1 x Servo motor interface
    • 1 x Potentiometers to simulate analog I/P
    • 1 x Relay module
    • 1 x RTC D51307
    • 1 x I2C EEPROM IC
    • 1 x RS232 + RS485 Interface with status LEDs
    • 1 x USB socket type B (for UART To USB interface) with status LEDs
    • 1 x AC power source socket (fuse protected) with ON/OFF switch
    • Pullup and pulldown resistor for every microcontroller pin (selectable between (pull-up, floating, pull-down)
    • Indication LED for every microcontroller pin
    • Pushbutton for every microcontroller pin (selectable between VCC or GND signal)
    • External crystal oscillators
    • Pin header male/female groups for every microcontroller PORT for external connections
    • Programming IDE: Supports MikroC For 8051 and keil for 8051
    • Includes ready to run codes for all included trainer components by Keil for 8051