8051 Microcontroller Trainer
(EMB100)
- 8051 microcontroller trainer (EMB100)
- Hard copy user manual
- Programming software
- Sample codes
- USB Cable A to B 1.5 m
- RS232 cable 1.5 m
- Laboratory PC
8051 Micro controller trainer is a benchtop kit that tends to familiarize the trainee with the different microcontroller components and connections. The kit is designed in the form of a lightweight portable plastic case equipped with a real microcontroller and various electronic components related to its functions to allow wide ranges of experiments. Kit is based on microchip 8051 architecture microcontrollers. Kit provides a large number of interface modules with configuration switches which open a wide range of experiments.
- 8051 microcontroller trainer consist of
- Embedded programmer (access via USB port with indication LEDs)
- Included microchip AT89S52 8-bit microcontroller with 8KB of ISP flash memory - 12MHz OSC.
- Integrated fixed DC power supply module:
+ 3.3V, +5V, +12V, -5V, -12V (fuse protected) with led indicators - accessed via 2mm sockets (for external modules) - Integrated variable DC power supply module: (fuse protected) with led indicators - accessed via 2mm sockets (for external modules): 0VDC: +5VDC and -5VDC: 0V
- 8 Digital switches
- Integrated pulse generator from 2 Hz : 1KHz
- Dip switches for configuring microcontroller I/O ports
- 4 x Seven segment modules
- 1 x (2 x 16 LCD module) contrast adjustable via potentiometer
- 1 x (64 X 128 GLCD module) contrast adjustable via potentiometer
- ADC: 1 x 4-channel12-bit resolution.
- Port expander: 1 x 16-Bit remote bidirectional I/O port
- 1 x keypad: 12-key
- 1 x Piezo buzzer module
- 1 x Speaker
- 1 x Temperature sensor DS1820
- 1 x Stepper motor interface through ULN2803
- 1 x DC motor interface
- 1 x Servo motor interface
- 1 x Potentiometers to simulate analog I/P
- 1 x Relay module
- 1 x RTC D51307
- 1 x I2C EEPROM IC
- 1 x RS232 + RS485 Interface with status LEDs
- 1 x USB socket type B (for UART To USB interface) with status LEDs
- 1 x AC power source socket (fuse protected) with ON/OFF switch
- Pullup and pulldown resistor for every microcontroller pin (selectable between (pull-up, floating, pull-down)
- Indication LED for every microcontroller pin
- Pushbutton for every microcontroller pin (selectable between VCC or GND signal)
- External crystal oscillators
- Pin header male/female groups for every microcontroller port for external connections
- Programming IDE: Supports MikroC For 8051 and keil for 8051
- Includes ready to run codes for all included trainer components by keil for 8051