Can-Bus Trainer
(EV104)
- Familiarization with the main components of each car's CAN-BUS system and the function introduction for every component.
- Demonstration of the CAN-BUS system's working principle and process.
- Measurement of sensor and actuator signals with a multimeter or oscilloscope.
- The system parameters are measured by connecting to the banana connector.
- Electrical signal parameters of system components.
- Identification of troubleshooting and fault.
- Learning about OBD 16-pin diagnostic connection for diagnosis.
- Enhancing the individual control module diagnosis.
- Identification of the electronic control unit (ECU).
- Learning how to read and delete error codes.
- Familiarization with the operating system's settings.
- Demonstration of turning on the actuators.
- Enhance how to encode and setup up the control units.
- Can-Bus Trainer (EV104).
- Hard copy user manual.
- Digital content (BI01).
The Can-Bus Trainer is designed to allow trainees to study the system`s construction and control systems work. The CAN-BUS unit has the necessary tools. The collection includes components utilized in the car sector. Educational and directive drawings on the set boost the efficiency of training. The inscriptions and symbols on the module were printed using a color printing diagram. The trainer is a stand-alone unit operation mounted on repositionable and fixable wheels.
- The Can-Bus Trainer is designed to demonstrate both the CAN BUS system's operation and the structure of the various systems. And the automotive industry's communication and control systems.
- The Education unit contains:
- Dashboard
- Engine ECU
- Smart Key, ignition module, lock module
- SRS Airbag ECU
- Central CAN Gateway module (ECU)
- Front and rear doors control modules
- Front and rear windows lifting motors
- Front and rear windows lifting switches
- The trainer includes a fault-setting module as well as a manual fault-setting module.
- On the panel, a diagnostic seat is installed that can be connected to an auto decoder to read fault codes, clear fault codes, and read data streams.
- The test terminals on the test panel can be used to detect the signals of the associated sensors and actuators, making fault analysis simple.
- The internal network is connected to every component. To help with understanding, a schematic of the network is presented.
- Banana plug jumpers can be used to connect or detach the modules' communication. On the stand, Low and High-speed CAN lines are connected or detached.
- CAN escape diagram for measuring and simulating system failures with built-in banana plug jumpers.
- The window raising motors are active and controlled by switches and door control modules, with the ability to simulate more than 10 system flaws using the vehicle's CAN gateway network
- The trainer also demonstrates a schematic diagram for the Can-Bus system can assist trainees in learning and analyzing the system.
- Operation module is equipped with an ON/OFF switch, emergency switch, and indication LED.
- The training unit is equipped with caster wheels underneath to ease the moving of the mounted units inside the workshop, in addition to the wheels’ braking mechanism that prevents the unit from sliding during operation.